Start here
$59Bench diagnostic
Inspection, troubleshooting and a written repair estimate.
Local 3D printer repair / Colorado Springs
Get the printer
printing again.
Drop-off diagnostics, repairs, tune-ups, new-printer setup and local on-site help. We inspect it, send an estimate, and do not order parts or continue work until you approve it.
Request repairAfter approval
$65/hrRepair labor
Billed in 15-minute steps. Replacement parts are listed separately at shop cost plus 25% sourcing and handling.
Maintenance
$99Tune-up
Cleaning, mechanical inspection, calibration and a test print. Parts extra.
Fresh out of the box
$129New printer setup
Assembly, firmware, calibration, slicer basics and a test print.
At your location
$149On-site first hour
Within the local service area. Additional time is $65 per hour.
How it works
No mystery repair bill.
1Tell us the printer and the problem.2Bring it to 4320 Barnes Rd, Suite 110.3We diagnose it and send an itemized invoice.4You approve and pay before parts or repair work continue.
Repair request
Tell us what it is doing.
Use your phone to take a photo of the printer, failed print, error message or damaged part. The photo helps us understand the problem before you bring it in.
Drop-off4320 Barnes Rd, Suite 110Colorado Springs, CO 80917Across from Skate City in the white strip mall